Wakol Buffalo Universal Glue 1 kg | 4 kg
This text has been translated automatically and may contain errors. It does not constitute a legally binding offer. Only the German texts apply.Wakol Buffalo Universal Glue 1 kg and 4 kg container Areas of application: Ground Wall Blanket Dispersion adhesive for the installation of Floor coverings such as PVC and textile coverings Wall coverings such as ceramic tiles, wallpaper underneath, cork wall coverings, etc Ceiling coverings such as hard foam panels on absorbent indoor surfaces. How it's done: Trowel notch according to TKB A2 for PVC coverings, C2 or C3 for ceramic tiles Consumption: approx. 350-1400 g/m²TKB A2 approx. 350 g/m² PVC coveringsTKB B2 approx. 500 g/m² Textile coverings and ceiling tilesC2 approx. 1400 g/m² Ceramic tilesC3 approx. 1200 g/m² Ceramic tiles Airing time: none Laying time: up to 30 minutes, depending on trowel notch Storage instructions: not below +5 °C, sensitive to frost Raw material basis: acrylate dispersion EMICODE: EC1 PLUS GISCODE: D1 Subfloors Screeds such as cement screeds, calcium sulphate screeds, mastic asphalt and V 100 chipboard as well as the room climate conditions must meet the requirements of DIN 18 365. Substrates must be even, permanently dry, absorbent, firm, free from cracks and impurities. Before PVC installation and generally on calcium sulphate and mastic asphalt screeds, prime with WAKOL D 3040 Primer Concentrate or WAKOL D 3035 Dispersion Primer and fill with WAKOL Z 615 Levelling Compound, low dust at least 2 mm thick. Observe the dilution ratio of the precoat concentrate and the drying times of the precoats. Processing and Stir the adhesive before use. For installation in wall and floor areas, apply adhesive evenly to the substrate using a notched trowel. Use TKB A2 notched trowel for PVC flooring and TKB B2 notched trowel for carpet squeezing. Avoid glue nests. Immediately insert the covering and press down or rub well. After approx. 20 minutes, rub the stiff belae once again. If tiles are to be bonded to old, fixed ceramic tiles, a thin layer of adhesive must be applied to the cleaned old tiles 1 - 2 days before laying. The new tiles are then laid as usual. Use toothed trowel TKB C3 or TKB C2, depending on the back of the tile. Grouting of ceramic tiles on absorbent wall surfaces after 1 day, on non-absorbent surfaces and on the floor after 7 days at the earliest. For ceiling tile installations, apply adhesive evenly to the underside of the tile using a notched trowel TKB B2. Position the plate immediately and press firmly. See technical data for further information.